53
l)
m)
4.24 - Adding the Epropulsion Motor
Remove the hatch in the front of the console.
This will reveal a deck gland with a mousing
line emerging from it labelled ‘battery’.
Remove the 3 screws from the deck gland and pass
the larger power cable through the gland assembly
(see image to the right).
Pull the cable through from the front hatch.
Re-assemble the deck gland and ret the 3 screws
Add the motor lifting line as shown and cleat it o.
You can now remove the chock which you added in step h.
With the motor in the fully up position, make a
mark on the extrusion so you know how far to
pull it in when you are on the water.
3
3
1
1
2
2
Knot #1
To Next Page
Loading...
