54
n)
o)
4.24 - Adding the Epropulsion Motor
Bottom Plate Installation
Drill six Ø6.5mm holes in the bottom plate
according to the size shown below.
42.50mm
25mm
26mm
6 x
6.5mm
Fix the hull plate to the skeg mount
with 6 x M6 x 16mm hex socket
countersunk bolts with M6 locknuts.
Fitting the Communications Module
Fit the communications module through
the front hatch on the console. Attach it
to the wooden bulkhead in the console
using the M4 screws provided.
Attach the the cables from the motor
and the throttle to the 2 connectors on
the side of the module.
Note: Make sure the correct cable is
connected.
To Next Page
Loading...
