Universal System Controller
T2-B
12
CHAPTER 2 | INTRODUCTION
CLEANING
Occasional cleaning may be required, depending on use. It is
recommended that you create a “Clean” button somewhere on the Home
page of the T2-B. This button should link to a page that does not contain
commands or macros that could be inadvertently executed while cleaning
the unit. The “Clean” page could contain a text message or graphic of your
choosing such as:
To clean your T2-B, lightly dampen a lint-free cloth with a glass cleaner or
mild detergent, and wipe the touchscreen, keypad and outer surfaces.
BATTERY AND DOCKING STATION
The T2-B uses a Lithium-Ion rechargeable battery. This battery does
not exhibit any type of “Memory Effect” from being charged too often.
Since the T2-B can safely be charged after each use, a docking station is
included for convenience. If left out of the docking station, the T2-B will
remain in sleep mode for 1 – 2 months before shutting down. At that point
the battery must be recharged.
The T2-B Docking Station can be placed on a at surface such as a shelf or
table, or it can be mounted to a wall using the mounting holes on the back
of the unit.
If the T2-B battery capacity is reduced to approximately one hour of
remaining run-time, a low battery icon will appear in the upper left corner
of the display:
At this point the T2-B must be placed into the docking station to recharge
the battery.
The docking station LED illuminates red to indicate a charge in progress.
The LED will illuminate blue when the battery in the unit is fully charged
To Next Page
Loading...
