RuarkAudio R1 - FM Radio Operations; Change FM Station

EN
DA
DE
ES
FR
IT
JA
KO
NL
NO
PL
RU
ZH
FM radio
The rst time you use FM on your R1, or if the FM
station list is empty, it will automatically perform a
station scan to create a list of available stations.
Change station
Press or to show the station list. Pressing it
again shows the next or previous station, to tune to a
station, select it by pressing the CONTROL KNOB, or
wait a few seconds for it to automatically select.
Once the station list is displayed, you can also scroll
through the list by rotating the CONTROL KNOB and
selecting a station by pressing the knob.
You can also show the station list by selecting
MENU > Station list.
To seek the next or previous station, press and hold
or .
The station frequency is normally replaced by the
station name a few seconds after tuning into an FM
station.
FM radio text (RDS/RBDS)
RDS (Radio Data System) is information about the
programme or track broadcast by the station. Select
what information is shown from MENU > Info.
Manual tune
Select MENU > Manual tune then rotate the
CONTROL KNOB to change the frequency and press
it to select that station.
Save preset
You can store 8 FM stations in your preset list. If RDS
data is not available, your R1 will store the frequency
instead of the station name in the preset list.
Recall preset
‘See Common functions’ section.
Station scan
If the station list is empty the radio will automatically
perform a full scan as soon as you switch to FM.
We recommend you periodically update the station
list by selecting MENU > Station scan.
Sensitivity
By default, the FM sensitivity is set to Strong stations.
Change it so it also tunes into weaker stations by
selecting Menu > Sensitivity > All stations.