Need help?Do you have a question about the Rubbermaid 3748 and is the answer not in the manual?
General| Brand | Rubbermaid |
|---|---|
| Model | 3748 |
| Category | Outdoor Storage |
| Language | English |
Choose a level site with good drainage for optimal door and roof function.
Verify all parts are present; names are molded into each part.
Assemble right side panel to back panel by aligning slots and tabs.
Repeat the assembly process for the left side panel.
Insert the floor panel between the side panels, tapping with a mallet if needed.
Align door hole with pin, rotate, and snap bottom pin into floor hole.
Follow the same procedure as step 6 for the right door.
Insert the roof support rod into the guide formed in the right panel.
Attach the rear of the roof to the pivot point on the back wall until it snaps.
Regularly check shed assembly and site levelness for continued proper function.
Clean the shed with a garden hose or mild detergent and water, avoiding abrasive cleaners.
Secure shed to fixed objects or ground using stakes via pre-drilled holes. Wear safety glasses.
Add a shelf by cutting lumber to fit pre-molded brackets, clipping corners towards the back.
To Next Page
