Cookbook Configuration
114
(1) Choose Firewall > Security Zone Config > Zone Policy Config.
(2) Click Add to access the Add Policy page.
(3) Configure the policy parameters according to the following information and click OK.
Control the access between the designated source security zone and the
destination security zone.
Control the access between the designated source security zone and the
destination security zone.
Indicate the policy priority. The lower value indicates the higher priority. The policy
of higher priority is matched preferentially if multiple zone policies are configured.
The description of the zone policy.
Access control for packets from the designated source IP address. Click IP
Resource Configuration to add a new IP address object. For details, see 1.4 IP
Resource Configuration.
To Next Page
Loading...
Need help?
General
