Ruijie RG-EG210G-E Series User Manual

Ruijie RG-EG210G-E Series Routers Hardware Installation and Reference Guide System Debugging
4 System Debugging
4.1 Establishing the Debugging Environment
Establishing the Debugging Environment
Connect the PC to the LAN port of the router, and configure the PC to obtain an IP address automatically.
Or connect the cable of AP to the LAN port of the router. After the AP is powered on, it will broadcast the SSID starting
with @Ruijie-m. You can connect to the SSID for configuration.
Figure 4-1 Schematic Diagram of the Configuration Environment
4.2 Startup Check
4.2.1 Checking before the Device is Powered on
 The router is fully grounded.
 The power cable is correctly connected.
 The power supply voltage complies with the requirement of the router.
 The cable of the PC is properly connected to the LAN port of the router. The parameter settings are correct.
4.2.2 Checking after Program Startup (Recommended)
After power-on, you are recommended to perform the following checks to ensure the normal operation of follow-up
configurations.
 Check whether the status of the device indicator is normal.

Ruijie RG-EG210G-E Series Specifications

General

Brand	Ruijie
Model	RG-EG210G-E Series
Category	Network Router
Language	English