Ruijie RG-S5310-48GT4XS-P-E User Manual (English)

Questions and Answers:

D
Diana SchroederAug 10, 2025
What to do if the AC power module does not work on Ruijie RG-S5310-48GT4XS-P-E?
- T
  Thomas Miller DDSAug 10, 2025
  If the AC power module of your Ruijie Switch isn't working, here's what to do: 1. Unplug the power cord from the power supply module. 2. Make sure the power cord is properly connected to the power socket. 3. Verify the power cord is securely connected to the power supply module itself. 4. Ensure the power supply module is correctly seated. If needed, remove the module and inspect its connector.
H
hamptonamyAug 17, 2025
How to fix link setup issues on the fiber port of a Ruijie RG-S5310-48GT4XS-P-E?
- B
  Brian WardAug 17, 2025
  If you're having trouble setting up a link on the fiber port of your Ruijie Switch, consider the following: * Ensure the receiving and transmitting ends aren't reversed. The transmitting end must connect to the receiver on the other end. Try swapping the fiber-optic cable connections to confirm. * Check that the wavelengths of the SFP modules on both sides are consistent (e.g., a 1310 nm SFP module should not connect to a 1550 nm module). * Verify that the distance between the two sides doesn't exceed the maximum length specified on the SFP module. * Confirm that the speeds of both sides match and that the optical fiber type meets the requirements.
W
William JacksonAug 25, 2025
What to do if the serial port console has no output on a Ruijie RG-S5310-48GT4XS-P-E?
- C
  Crystal AdamsAug 26, 2025
  If there's no output on the serial port console of your Ruijie Switch, try these steps: 1. Check the serial cable to make sure it is working properly. 2. Make sure the connected serial port matches the configuration on the HyperTerminal. 3. Verify that the serial port configuration on the HyperTerminal is consistent with the settings in the Configuration Guide. 4. If there is still no output on the serial port, please contact Ruijie technical support.
J
jennifer26Sep 1, 2025
Why is the serial port console output garbled on my Ruijie Switch?
- K
  Kathryn BuchananSep 1, 2025
  If the serial port console output on your Ruijie Switch is garbled, it's likely due to a serial port configuration issue. Check that the baud rate configuration matches the settings in the Configuration Guide.

Ruijie RG-S5310-48GT4XS-P-E Specifications

General

Model	RG-S5310-48GT4XS-P-E
Device Type	Switch
Ports	48 x 10/100/1000Base-T, 4 x 10G SFP+
Switching Capacity	176 Gbps
MAC Address Table	16K
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)
Power Supply	AC 100V-240V
Dimensions (W x D x H)	440 x 44 x mm
Weight	4.5 kg