Runva EWP2500 - Maintenance; Routine Checks and Lubrication; Trouble Shooting

11
6. Retract Cable Assembly onto drum, first five wraps being careful not to allow
kinking, then winch cable must be wound onto the drum under a load of at least
10% rated line pull.
WARNING - Only replace the wire rope with the identical replacement part
recommended by the manufacturer.
1. MAINTENANCE
1. Periodically check the tightness of mounting bolts and electrical connections.
Remove all dirt or corrosion and always keep clean.
2. Do not attempt to disassemble the gearbox.
3. The gearbox has been lubricated using a high temperature lithium grease and is
sealed at the factory. No internal lubrication is required.
4.
TROUBLE SHOOTING
SYMPTOM
POSSIBLE CAUSE
SUGGESTED ACTION
Motor does not
turn on
-Switch Assembly
connected improperly
-Loose battery cable
connections
-Defective switch
assembly
-Defective motor
-Water has entered
motor
-Re-Insert switch assembly into the connector.
-Tighten nuts on all cable connections.
-Replace switch assembly.
-Check for voltage at armature port with Switch
pressed. If voltage is present, replace motor.
-Allow to drain and dry. Run winch until
completely dry.
Motor runs but
cable drum does
not turn
-Clutch not engaged
-Turn clutch to the “In” position. If problem
persists, ask a technician to check and repair.
Motor runs slowly
or without normal
power
-Insufficient current or
voltage
-Operate winch with vehicle motor running.
-Clean, tighten, or replace battery cable
connections.
Motor overheating
-Winch running for too
long
-Allow winch to cool down periodically.
Motor runs in one
direction only
- Loose or corroded
battery cable or motor
cable connections.
- Clean and tighten.
-Repair or replace switch assembly.