MODEL F71B/F71G/F67C/F67G/N75A/N75B
9
1.5. Installation
A. Installation notice
Before installation, read all those instructions completely. Then
obtain all materials and tools needed for installation.
The installation of product, pipes and circuits should be
accomplished by professional to ensure the product can operate
normally.
Perform installation according to the relative pipeline regulations
and the specification of Water Inlet, Water Outlet, and Drain Outlet.
B. Device location
① The filter should be located closely to drain.
② Ensure the unit is installed in enough space for operating and
maintenance.
③ The unit should be kept away the heater, and exposed outdoor.
Sunshine or rain will cause the system damage.
④ Please avoid to install the system in one Acid/Alkaline, Magnetic or
strong vibration circumstance, because above factors will cause the
system disorder.
⑤ Do not install the filter, drain pipeline in circumstance which
temperature may drop below 5℃, or above 50℃.
⑥ One place is recommended to install the system which causes the
minimum loss in case of water leaking.
C. Pipeline connection (Taking F71B for example)
① Install control valve
a.As the figure1-1shows, select the relevant riser pipe, glue the riser pipe
to the bottom strainer and put it into the mineral tank, cut off the
exceeding tube out of tank top opening. Plug the riser tube in case of
mineral entering.
To Next Page
Loading...
Need help?
General
