25
8. Can the air fryer lid come off?
Yes, it can. Open the lid and gently lift on the hinges, the joints will slide out. Do
not immerse the lid in water.
CLEANING AND MAINTENANCE
• Before cleaning, switch the unit off and disconnect the plug from the power socket.
• Allow the unit to cool down.
• Clean after each use.
• Wipe the unit with warm, soapy water using a sponge or dish cloth only. Normal dish
washing liquid should be sufficient.
• Use a non-abrasive sponge or damp dish cloth to clean the exterior of the unit. Do
not use bleach, solvents, abrasive cleaners or scouring pads to clean the exterior of
your appliance as it can be damaging to the finish.
• You may hand wash the removable parts (excluding air fryer lid). A dishwasher may
cause the surface to deteriorate, however, this will not affect the operation of the
appliance.
• Do not place the rubber ring and pressure cooker lid in the dishwasher, hand wash
only.
• Do not use bleach or other abrasive substances or solvents to clean your appliance
as it can be damaging to the finish.
• Remove the water box/ collector and rinse it thoroughly and let it dry.
• Clean the pressure cooker lid with warm soapy water, including the seal ring,
Pressure Release Valve, block proof cover, Float Valve and let them dry thoroughly.
• Gently wipe the air fryer lid with a slightly damp, clean soapy dish cloth. Do not
submerge the air fryer lid or appliance body in water.
• The Pressure Release Valve pops off easily by gently pulling it upwards. Be careful
not to damage supporting structure/parts under it.
• Clean the Pressure Release Valve and the holes with a small brush to ensure
smooth flow of steam during the release cycle.
• Wash the inner pot with a non-abrasive sponge and allow to air dry or use a towel.
• This appliance is for household use only and is not user-serviceable.
• Do not open or change any parts by yourself. Please refer to a qualified electrician or
return to the supplier if servicing is necessary.
• Let parts dry completely before reassembling.