8
pump noise
Occasionally, you may hear the pump working, then stop. Don’t worry about it, its
probably a bit bored.
warming milk
To warm milk for your coffee, follow the procedure for making froth, but immerse the
frother in the milk, so the steam bubbles up through the milk, warming it. Keep the
steam control towards the bottom end of the scale. If you use too much steam, you’ll
get watery milk.
care and maintenance
1 Unplug the machine and let it cool.
2 Squeeze the pressure release on the filter holder, to release any pressure/water
trapped between the brewing head and the filter holder.
2 Grip the filter holder handle, and turn it to your left, till it reaches the arrow on the
left, then lower it from the brewing head.
3 Flip the clip on the filter holder handle forward, and keep a finger on it while you tip
out the used coffee grounds. This’ll prevent it joining the coffee grounds in the bin.
4 Pull the clip back and remove the filter, and spacer.
5 Use a pin or needle to remove the rubber ring from
the spacer.
6 Remove the rubber spacer from the filter holder.
7 Remove the cup warmer cover, wash it in warm soapy
water, rinse and dry.
8 Lift the drip tray off the machine.
9 Lift the cover off the drip tray, then pour the contents
of the drip tray down the sink.
10 Wipe the drip tray, cover, and the body of the machine
with a damp cloth.
11 Wash the filter, filter holder and spacer, rinse and dry.
12 To reassemble, put the rubber ring inside the slot, in the spacer.
13 Turn the rubber spacer so the raised edge is facing upwards, then put it in the
groove, inside the filter holder.
14 Put the spacer into the filter holder, then put a filter into the filter holder.
15 Put the filter holder under the brewing head, align with the left arrow, lift up and
turn it to your right, till it reaches the arrow on the right.
16 Sit the cover on the drip tray, then lower the drip tray into the base.
17 To remove the frother, hold the steam head firmly, turn the frother anti-clockwise
till it stops, then pull it off the steam head.
18 Pull the nozzle off the steam head.
19 Wash the frother and nozzle in warm soapy water, rinse thoroughly, and dry.
20 If deposits have formed on the end of the nozzle, remove them with a pin.
21 To replace, hold the steam head and push the nozzle on to it till it stops. Turn the
frother so the grooves align with the tabs, push it on to the steam head and turn
clockwise a quarter of a turn till it stops
To Next Page
Loading...
Need help?
General
