For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 6pm & Saturday 9am – 1pm
or visit us at www.productcareuk.com
12
Installation
Water
• The appliance should be connected to the cold water mains using new
hose sets. Old hose sets should not be reused. In using only one water
tap or in case of only one water inlet valve, connect the inlet hose to the
cold water inlet valve.
Water inlet hose connection
• Be careful not to confuse hot water inlet and cold water inlet.
• Your machine has a single water (cold) inlet.
• To prevent leakages on the connection joints, 1 seal is included in the hose
packing.
• After all connections are completed, check for leakages around the
connection joints by turning on your tap completely and seeing if any
water escapes.
• Be sure that the water inlet hoses are not folded, twisted, crushed or
elongated by stretching.
Electrical connection
• Your washing machine is set to 220-240V and 50Hz.
• The mains cord of your washing machine is equipped with a specific
earthed plug. This plug should always be inserted to a earthed socket of 13
amps. The current value of the fuse should be 13 amps.
• We do not take responsibility for any damage that occurs due to non
earthed usage.
• Operating your appliance under low voltage will cause the life cycle of
your appliance to be reduced and its performance to be restricted.
To Next Page
Loading...
