Your appliance can be filled either through a plumbed water
intake, or manually filled.
Plumbed Water
The supplied water inlet pipe is attached to the inlet at the rear of
the appliance by removing the White cap and screwing on the
inlet pipe. The other side of the inlet pipe is connected to a ¾ inch
threaded tap. Adapters (not supplied) can be used to fit to
alternative water sources.
IMPORTANT – If the symbol is displayed, there is not enough
water pressure to operate.
Manually Filled
Ensuring the inlet cap is in place, unscrew the cap on top of the
appliance and fill with water until the appliance beeps.
IMPORTANT – Your appliance must be switched on when manually
filling with water.
To Next Page
Loading...
