Load the appliance in an appropriate manner as outlined in this
manual, add the required detergent, and close the door.
Once the door is closed, turn the appliance on and follow the
water fill instructions in this manual.
Select the desired program by pressing the ‘P’ button. Once the
program is selected, press the ‘Start/Pause’ button to begin
operation.
When the end of the program is reached, the appliance will beep
for 8 seconds. Turn off the appliance pressing the ‘On/Off’ button.
NOTE – we recommend opening the door to assist in drying for 30
minutes after a cycle has finished.
You can modify the wash program within the first few minutes of a
cycle.
• Press the ‘Start/Pause’ button
• Hold the ‘P’ button for 3 seconds, and then you can select the
required program.
• Once the desired program is selected, press the ‘Start/Pause’
button to resume.
To Next Page
Loading...
