The water hardness/salt level must be set according the water
condition in your local area. The water softener is designed to
remove minerals and salts from the water, which would have a
detrimental or adverse effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your
water is. Your local Water Authority can advise you on the hardness
of the water in your area.
Setting the Hardness Level
1. Close the door and within 60 seconds after pressing the power
button, press ‘Program’ and hold for 5 seconds.
2. Press the ‘Program’ button to cycle through the hardness
settings, indicated as H1-H6 (default is H3).
3. After no input for 5 seconds, the selected hardness level will be
set.
1) German degree of measurement for the water hardness
2) millimol, international unit for water hardness
3) factory setting
4) Regeneration of water softener. The water softener (dishwasher salt) must be
replenished regularly to maintain the softening function. During regeneration, an
additional 0.2 litres of water is required, energy consumption is increased by 0.01kWh and
the programme is extended by 4 minutes.
To Next Page
Loading...
