To Next PageTo Next Page
Need help?Do you have a question about the Ruud RP13 and is the answer not in the manual?
Inspect unit for shipping damage and verify correct components.
Process for specifying heat pump equipment based on load calculations.
Technical specifications including electrical and physical attributes.
Provides physical dimensions for various RP models.
Emphasizes correct installation for optimal performance and energy efficiency.
Guidance on selecting an appropriate outdoor unit placement.
Guidance on unit placement to avoid operational problems and ensure proper airflow.
Advice on selecting locations to prevent rust and deterioration from corrosive elements.
Clearances for units with limited space, impacting capacity and efficiency.
Recommendations for unit placement to minimize noise and customer dissatisfaction.
Safety and guidelines for securing and elevating the unit.
Recommended method for securing equipment against wind and seismic activity.
Lists essential tools for working with R-410A systems.
Details on R-410A refrigerant properties, application, and composition.
Key information and best practices for R-410A refrigerant.
Guidelines for replacing existing refrigerant lines and filter driers.
Warnings and recommendations for selecting matched indoor coils for R-410A systems.
Best practices for installing interconnection tubing between indoor and outdoor units.
Procedures for adjusting refrigerant charge based on line set length and configuration.
General procedures for installing tubing, making connections, and leak testing.
Instructions for low-voltage wiring between thermostat and units.
Information on connecting the main power supply to the unit.
Essential safety step for proper unit grounding.
Initial steps before operating the system, including crankcase heater energization.
Procedures and importance of verifying correct airflow for system performance.
Crucial steps for removing air/moisture and detecting leaks.
Procedures for verifying and adjusting the system's refrigerant charge.
Information on adding crankcase heaters for protection against refrigerant migration.
Explanation of pressure controls that protect the compressor.
Operation and troubleshooting of the defrost control system.
Component that controls the fan based on head pressure for low ambient operation.
A flowchart to diagnose cooling system mechanical issues.
A flowchart to diagnose heating system mechanical issues.
A comprehensive chart linking symptoms to possible causes and remedies.
Detailed charts for analyzing specific compressor and electrical issues.
Wiring diagram for single-phase units with PSC fan motors.
Wiring diagram for 3-phase, 208/230V models.
Wiring diagram for 3-phase, 460/575V models.
General| HSPF Rating | Up to 8.5 HSPF |
|---|---|
| Refrigerant Type | R-410A |
| Compressor Type | Scroll Compressor |
| Stages | Single-Stage |
| Cooling Capacity (BTU/h) | 60, 000 BTU/h |
| Heating Capacity (BTU/h) | 60, 000 BTU/h |
| Warranty | 10-Year Limited Warranty |
