INDICATOR LED
POWER: When illuminated, the HydroSalt™ has input power.
GENERATING: Model in normal operation, the LED will be steady. If it is
flashing, check the pool water.
SUPER CHLORINATE: Illuminates during Super Chlorination. See description
above.
REMOTE : The part is controlled by a remote control system(not available).
NO FLOW: When illuminated, the flow switch has detected no flow and
HydroSalt™ is NOT generating chlorine. A flashing LED indicates that the flow
is restored, but there will be a 60 second delay before generation is
re-established.
CHECK SALT: If flashing, the salt level is low (below 2500ppm) and
HydroSalt™ is generating at low efficiency. When illuminated steady, the salt
level is too low and HydroSalt™ has shut down.
Note: Before adding large quantities of salt, it is advisable to have your salt level
professionally checked.
HIGH SALT: When illuminated, the salt level is too high and HydroSalt™ has
shut down. The pool water must be diluted with fresh water before operation is
To Next Page
Loading...
