should not be removed.
Spring Start-up
DO NOT turn HydroSalt™ on, until the pool water chemistry has been balanced to proper
levels.
INSTALLATION
WARNING :
Before Installation, consult your state & county codes. Installation must be
performed in accordance with local NEC codes.
Preparing Pool Water:
The pool’s chemistry must be balanced BEFORE activating the HydroSalt™. It is
recommended that you consult a pool professional for the initial balancing each season.
NOTE: At the beginning of each season, add metal remover and polymer based (non
copper) algaecide to the pool, per manufacturer’s instructions. This ensures a quick,
trouble free transfer to the HydroSalt™ system.
Mounting the HydroSalt™ Control
The HydroSalt™ is contained in a rain tight enclosure that is suitable for outdoor
mounting. The control must be mounted a minimum of 5 ft. (2 meters) horizontal distance
from the pool/spa. The control is designed to mount vertically on a flat surface with the
knockouts facing downward. Because the enclosure also acts as a heat sink (disperses
heat from inside the box), it is important not to block the four sides of the control.
Do not mount the HydroSalt™ in a panel or tightly enclosed space.
To Next Page
Loading...
