9
REN-O-THIN
OPERATION
PRE-OPERATION CHECK LIST
(OPERATOR'S RESPONSIBILITY)
- Review and follow all safety rules and safety
decal instructions.
- Check that all safety decals are installed and in
good condition. Replace if damaged.
- Check to make sure all shields and guards are
properly installed and in good condition. Be sure
the discharge shield is installed.
- Check that all hardware is properly installed and
secured.
- Check to be sure engine is free of dirt and
debris. Pay particular attention to the cooling
ns, governor parts and mufer. Clean air intake
screen. Check air cleaner; service is necessary.
- Visually check for loose or damaged parts and
fasteners. Repair or replace as needed before
unit is placed into operation.
To prevent injury due to rotating blades,
never place hands or feet beneath the
equipment at any time.
To prevent injury from thrown blades, never
operate equipment with reel blades that
are cracked, badly bent, missing, or in any
abnormal condition.
- Inspect area and remove stones, branches or
other hard objects that might be thrown, causing
injury or damage.
- Clean area around oil ll dipstick. Remove
dipstick and check to be sure oil is in operating
range (between marks on dipstick). Add oil
if necessary but DO NOT OVERFILL. Install
dipstick assembly rmly until cap bottoms out on
tube. Dipstick assembly must always be secured
into ll tube when engine is running.
- Check all lubrication points and grease as
instructed in manual.
- Perform a functional check of the Blade Clutch
system each time you operate the unit.
FUELING
- Fill fuel tank with good quality, clean, unleaded
regular petrol (gasoline). Do not use hi-test fuel.
- Use a funnel to avoid spilling.
WARNING
TO CHECK OR ADD FUEL:
– Do it outdoors
– Do not smoke
– Stop engine; allow to cool
– Fill to one inch below bottom
of ller neck
– Do not overll
– Clean up spilled fuel
- Check the reel for bent or broken blades; replace
as necessary.
To Next Page
Loading...
Need help?
General
