2mmormore
(0.08" or more)
Chapter 1 Operation Procedures
(Note)
When
reusing a plate with the plate tail edge
waved 2
mm
(0.08")
or
more, the plate tail
edge may not
be
able to
be
inserted correctly.
When storing used plates, please put the used
plates
on
a flat surface so that the plate will
not become wavy.
--~-'
2) Mount a polyester plate or paper master.
(1)
(2)
Bend the plate tail edge fully pushing it down around
the guide
(1)
using
the
polyester
plate
and
paper
master bender.
Check
that
the
plate
tensioning
knobs
(1)
are
properly loosened.
(Leading edge, Tail edge)
Check
that
the
standard
lines (1)
of
the
diagonal
image adjustment are aligned.
The
lines
can
be
adjusted
by
turning the diagonal
image adjustment
knob
(2).
Operation Edition - 19
To Next Page
