Chapter 2 Periodic Inspection
<Adjustment procedures>
Loosen the lock nuts (1) and
tum
the pressure adjustment nuts (A) to
adjust it.
The pressure adjustment nuts are located on both the operation and non
operation sides. When turning them in the direction
of
the arrow on the
nuts, the pressure will be increased.
c. The pressure between the metering roller and water fountain roller (D)
<Checking and adjustment procedures>
Maintenance Edition - 18
Check that the dampening solution is supplied into the water fountain
until the level
of
the dampening solution reaches the water fountain roller.
Shift the metering roller release
lever
in
the direction
of
the
arrow
(
~
position)
to
contact the metering roller with the water fountain roller.
Run the press and
tum
the metering roller pressure adjustment knobs
(operation side and non operation side) in
the"-"
direction (clockwise)
and release the pressure.
After
that,
turn
the
adjustment
knobs
in
the
"+"
direction
(counterclockwise) slowly until the aqua film on the metering roller just
cuts.
Then tum the adjustment knobs in
the"+"
direction (counterclockwise)
10 clicks more from the position that the aqua film was cut.
To Next Page
