Ryobi BDS4600 - Disc Sanding Operations; Sanding Outside Curves; Sanding Small End Surfaces

Always sand
outside curves
on
the
left side of centre
on
the sanding
disc as shown.
WARNING:
Applying
the
workpiece
to the
right side of
the disc
could cause
workpiece
to fly up
(kickback)
and
result in an
injury.
I
SANDING
SMALL
END SURFACES
ON
THE SANDING
DISC
Note: Use
of a
mitre
gauge
is
recommended
{or this
operation.
Always
move the
work across
left
side of centre
on the
sanding
disc
face as shown.
WARNING:
Applying
the
workpiece
to the
right side
of
the disc
f irst
could
cause
workpiece
to
f ly u
p
(kickback)
and result
in an
injury.
Always
position
the
workpiece
to
the left of centre
on
sanding
disc
with disc
rotating counterclockwise
as shown,
The table
may be tilted
for
bevelled
work.
Workcrece