Ryobi BGH615 - Loose Parts List; Parts for BGH615; Parts for BGH625; Parts for BGH825

Page 7
n Washers (6 mm)........................................................... 2
n Washers (8 mm)........................................................... 6
n Hex Bolts (6 mm x 6) ................................................... 2
n Hex Bolts (8 mm x 8) ................................................... 4
n Hex Bolts (8 mm x 14) ................................................. 2
n Operator's Manual
LOOSE PARTS LIST – BGH625
The following items are included with your Bench Grinder:
n Shield Rods – one left, one right ................................. 2
n Shield Rod Brackets with Hardware............................ 2
n Safety Shields ............................................................. 2
n Spark Deflectors.......................................................... 2
n Work Rests – one left, one right .................................. 2
n Lock Washers (5 mm).................................................. 2
n Washers (5 mm)........................................................... 2
LOOSE PARTS LIST
LOOSE PARTS LIST – BGH615
The following items are included with your Bench Grinder:
n Shield Rods – one left, one right ................................. 2
n Shield Rod Brackets with Hardware............................ 2
n Safety Shields.............................................................. 2
n Spark Deflectors – one left, one right.......................... 2
n Work Rests – one left, one right .................................. 2
LOOSE PARTS LIST – BGH825
The following items are included with your Bench Grinder:
n Shield Rods – one left, one right ................................. 2
n Shield Rod Brackets with Hardware............................ 2
n Safety Shields.............................................................. 2
n Spark Deflectors.......................................................... 2
n Work Rests – one left, one right .................................. 2
n Lock Washers (5 mm).................................................. 2
n Washers (8 mm)........................................................... 2
n Phillips Screws (5 mm x 8) .......................................... 2
n Hex Bolts (8 mm x 14) ................................................. 2
n Adjustment Knobs....................................................... 2
n Hex Nuts (5 mm).......................................................... 2
n Washers (5 mm)........................................................... 2
n Operator's Manual
n Washers (5 mm)........................................................... 2
n Washers (8 mm)........................................................... 2
n Phillips Screws (5 mm x 8) .......................................... 2
n Hex Bolts (8 mm x 14) ................................................. 2
n Hex Bolts (5 mm x 10) ................................................. 2
n Operator's Manual
ADJUSTABLE WRENCH
Fig. 2
TOOLS NEEDED
The following tools (not included) are needed for assembly and alignment:
7 MM, 10 MM, AND 12 MM
COMBINATION WRENCH
PHILLIPS SCREWDRIVER