Ryobi BT3000 User Manual

OPERAT0R'S MANUAL
10 in. (254 mm) TABLE SAW / BT3000
SPECIFICATIONS:
Blade Diameter 10 in. (254 mm)
Blade Arbor 5/8 in. (16 mm)
Cutting Depth at 0° 3-9/16 in. (90.5 mm)
Cutting Depth at 45° 2-1/2 in. (63.5 mm)
Rating 120 Volts, 60 Hz-AC Only
15 Amperes
Output Speed 4,800 RPM
Net Weight Without Workstand 75 Lbs. (34.1 kg.)
Net Weight With Workstand 107 Lbs. (48.6 kg.)
Save This Manual For Future Reference
CONGRATULATIONS AND THANK YOU FOR BUYING THIS RYOBI 10 in. PRECISION CUTTING SYSTEM.
Your new saw has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and
operator safety. Properly cared for, it will give you years of rugged, trouble-free performance.
CAUTION: Carefully read through this entire operator's manual before using your new saw.
Pay close attention to the Rules for Safe Operation, Warnings, and Cautions. If you use your saw properly and only for what
it is intended, you will enjoy years of safe, reliable service.

Ryobi BT3000 Specifications

General

Motor Power	15 Amp
Blade Diameter	10 inches
Type	Table Saw
Arbor Size	5/8 inch
Voltage	120 V
No-Load Speed	4800 RPM
Bevel Capacity	0-45 degrees

Summary

Unpacking and Checking Contents

Tools Required for Setup

Lists the necessary tools for assembling the table saw.

Identify Loose Parts

Visual guide and list to verify all included parts after unpacking.

Features and Components

Saw Overview and Controls

Introduces saw features, explains operating components, and power switch.

Blade, Speed, and Wiring Specs

Details on recommended blades, operating speed, and electrical wiring.

Assembly Instructions

Frame and Rails Assembly

Steps for assembling the saw frame and installing rails.

Table and Fence Installation

Guide for installing the miter table, accessory table, and rip fence.

Blade and Guard Assembly

Procedures for checking blade installation and mounting the blade guard.

Operation and Usage

General Operation and Safety

Covers grounding, types of cuts, cutting tips, and kickback avoidance.

Blade Adjustments and Scaling

Guides for adjusting blade depth, angle, and setting the scale for accurate cuts.

Cutting Procedures

Detailed instructions for performing various cuts including cross, miter, rip, bevel, and specialty cuts.

Maintenance and Adjustments

General and Specific Maintenance

Routine checks, cleaning, lubrication, and blade angle adjustments.

Fence and Table Alignment

Procedures for aligning the rip fence, miter locking clamps, and rails.

Sliding Miter Table Adjustments

Checks and adjustments for the sliding miter table and fence parallelism.

Lubrication and Troubleshooting

Lubrication of Moving Parts

Specific areas requiring lubrication for smooth operation of the saw.

Troubleshooting Common Issues

Guide to diagnosing and resolving common problems with the table saw.

Accessories and Service

Recommended Accessories

List of optional accessories designed for the table saw.

Service and Parts Ordering

Information on obtaining repair parts, service centers, and model number recording.