Page 37
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Saw does not make accurate 90 or
45 degree cuts. Positive stops inside cabinet need
adjusting (Bevel Cuts). Adjust positive stops.
Miter gage is misaligned
(Miter Cuts). Adjust the miter gage.
Blade adjusting handle is hard to
turn. Gears or Screw Post inside cabinet
are clogged with sawdust. Clean the gears or screw post.
Saw does not start. Motor cord or wall cord is not
plugged in. Plug in motor cord or wall cord.
Circuit fuse is blown. Replace circuit fuse.
Circuit breaker is tripped. Reset circuit breaker.
Cord or switch is damaged. Have the cord or switch replaced at
a RYOBI AUTHORIZED SERVICE
CENTER.
Blade makes poor cuts Blade is dull or dirty. Clean, sharpen or replace blade.
Blade is wrong type for cut being
made. Replace with correct type.
Blade is mounted backwards. Remount blade.
Blade does not lower when turning
blade adjusting handle. Back side of riving knife has come
in contact with saw table. Realign and adjust the riving knife.
Locking lever is not at full left
position. Move locking lever to left.
Motor labors in rip cut. Blade not proper for rip cut. Change blade; rip blade typically
has fewer teeth such as Ryobi
4650324, 24 tooth, carbide rip
blade.
To Next Page
Loading...
Need help?
General
