ENGLISH
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
3
Original Instructions
Safety, performance, and dependability have
been given top priority in the design of your
cordless brushcutter and line trimmer.
INTENDED USE
The cordless brushcutter and line trimmer is
intended to be used only by adults who have
read and understood the instructions and
warnings in this manual and can be considered
responsible for their actions.
This product is intended only for outdoor use
in a well-ventilated area. For safety reasons,
the product must be adequately controlled by
a two-handed operation.
When fi tted with the line trimmer head (and
appropriate guard), the product is intended
for cutting long grass, pulpy weed, and similar
vegetation at or about ground level. When
fi tted with the TRI-ARC blade (and appropriate
guard), the product can also cut bushes. The
product is not designed to be fi tted with a saw
blade.
The cutting plane should be approximately
parallel to the ground surface.
The product should not be used to cut or trim
hedges, bushes, or other vegetation where
the cutting plane is not parallel to the ground
surface.
Use the product for cutting grass and light
weeds only. Do not use the product for any
other purpose.
GENERAL SAFETY WARNINGS
WARNING! Read all safety warnings and
all instructions. Failure to follow the warnings
and instructions may result in electric shock,
fi re, and/or serious injury.
WARNING! When using the product, the
safety rules must be followed. For your own
safety and that of bystanders, read these
instructions before operating the product.
Please keep the instructions safe for later use.
WARNING! The product is not intended to
be used by children or persons with reduced
physical, mental, or sensory capabilities.
Children should be supervised to ensure that
they do not play with the product.
WARNING! Some regions have regulations
that restrict the use of the product. Check with
your local authority for advice.
WARNING! Inspection after dropping or other
impacts: Thoroughly inspect the product and
identify any problems or damage to it. Any part
that is damaged should be properly repaired or
replaced by an authorised service centre.
TRAINING
■ Read the instructions carefully. Be familiar with
all the controls and the proper use of the product.
■ Never allow children or people who are
unfamiliar with the instructions to use the
product. Local regulations may restrict the
age of the operator.
■ Keep bystanders, children, and pets 15 m
away from the area of operation. Turn off
the product if anyone enters the area.
■ Never use the product while tired, ill, or under
the influence of alcohol, drugs, or medication.
■ Keep in mind that the operator or user
is responsible for accidents or hazards
occurring to other people or their property.
PREPARATION
■ Wear full eye and hearing protection while
operating the product. If working in an area
where there is a risk of falling objects, head
protection must be worn.
■ The use of hearing protection may restrict
the operator’s ability to hear warning
sounds. Pay particular attention to potential
hazards around and inside the work area.
■ Wear heavy, long trousers, boots, and
gloves. Do not wear loose-fitting clothing,
short trousers, or jewellery of any kind. Do
not use the product with bare feet.
■ Secure long hair so that it is above shoulder
level to prevent entanglement in moving parts.
■ Before use and after any impact, check that
there are no damaged parts on the product. A
defective switch or any part that is damaged
or worn should be properly repaired or
replaced by an authorised service centre.
■ Make sure that the cutting attachment is
properly installed and securely fastened.
■ Never operate the product unless all guards,
deflectors, and handles are properly and
securely attached.
■ Consider the environment in which you are
working. Keep the working area free from wires,
sticks, stones, and debris, which, if struck by
the cutter, can become thrown objects.
To Next Page
Loading...
