Page 8
KNOW YOUR BUFFER/POLISHER
See Figure 1.
Before using the buffer/polisher, familiarize yourself with
all operating features and safety requirements.
WARNING:
Do not allow familiarity with your buffer/polisher to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
Your new buffer/polisher is equipped with the following
features.
CORD
The buffer/polisher has a 6 ft. (1.8 m) power cord.
FEATURES
APPLICATION BONNET
The reusable application bonnet is made of synthetic
tufted material.
POLISHING BONNET
The reusable polishing bonnet is made of 100% terry cloth.
FOAM PAD
The foam pad is 6 in. (152 mm) in diameter.
ON/OFF SWITCH
The on/off switch is located on the side of the buffer/
polisher.
MOTOR HOUSING
The air vents for the motor are located on the sides of the
motor housing.
Fig. 1
MOTOR
HOUSING
ON/OFF
SWITCH
CORD
FOAM PAD
AIR VENT
To Next Page
Loading...
