Ryobi RCP254 - Troubleshooting

13

  
Engine fails to start. Engine switch is in the off position.
No fuel in tank.
Spark plug shorted or fouled.
Spark plug is broken (cracked
porcelain or electrodes broken).
Ignition lead wire shorted, broken, or
disconnected from spark plug.
Ignition inoperative.
Move switch to start.
Fill tank.
Replace spark plug.
Replace spark plug.
Replace lead wire or attach to spark
plug.
Contact authorised service centre.
Engine hard to start. Water in petrol or stale fuel mixture.
Too much oil in fuel mixture.
Engine is under or over choked.
Weak spark at spark plug.
Drain entire system and rell with fresh
fuel.
Drain and rell with correct mixture.
Adjust choke as necessary.
Contact authorised service centre.
Engine lacks power. Air lter clogged. Clean or replace air lter.
Engine overheats. Insufcient oil in fuel mixture. Mix fuel as described in starting
instructions.