8
WARNING
6HUYLFLQJ UHTXLUHV H[WUHPH FDUH DQG NQRZOHGJH
DQG VKRXOG EH SHUIRUPHG RQO\ EH D TXDOL¿HG VHUYLFH
technician. For service we suggest you return the
product to your nearest authorized service center for
repair. When servicing, use only identical replacement
parts.
WARNING
Disconnect from the power supply before adjustment,
maintenance or cleaning. Failure to do so could result in
serious personal injury.
Ŷ <RXPD\RQO\PDNHDGMXVWPHQWVRUUHSDLUVGHVFULEHG
in this manual. For other repairs, contact the authorized
service agent.
Ŷ &RQVHTXHQFHV RI LPSURSHU PDLQWHQDQFH PD\ FDXVH
WKHFKDLQEUDNHDQGRWKHUVDIHW\IHDWXUHVWRQRWIXQFWLRQ
correctly, thus increasing the potential for serious
injury. Keep your chainsaw professionally maintained
and safe.
Ŷ 6KDUSHQLQJWKHFKDLQVDIHO\LVDVNLOOHGWDVN7KHUHIRUH
the manufacturer strongly recommends that a worn or
dull chain is replaced with a new one, available from
your authorised Ryobi service centre. The part number
is available in the product specification table in this
manual.
Ŷ Follow instructions for lubricating and chain tension
FKHFNLQJDQGDGMXVWPHQW
Ŷ After each use, clean the product with a soft dry cloth.
Ŷ &KHFNDOOQXWV EROWVDQG VFUHZV DWIUHTXHQW LQWHUYDOV
IRU VHFXULW\ WR HQVXUH WKH SURGXFW LV LQ VDIH ZRUNLQJ
condition. Any part that is damaged should be properly
repaired or replaced by an authorized service centre.
REPLACING GUIDE BAR AND SAW CHAIN
See page 22 - 23.
1. Disconnect the product from its power supply. Wear
protective gloves.
8QVFUHZ WKH JXLGH EDU ORFNLQJ NQRE E\ WXUQLQJ LW
FRXQWHUFORFNZLVHXQWLOWKHVSURFNHWFRYHUFRPHVORRVH
5HPRYHWKHVSURFNHWFRYHU5HPRYHWKHEDUDQGVDZ
chain from unit.
To replace the bar with a new one, loosen the screw of
the chain tension assembly. Mount the chain tension
assembly on to the new bar and tighten the screw.
5. 3XWWKHQHZFKDLQLQWKHFRUUHFWGLUHFWLRQRQWRWKHEDU
DQG PDNH VXUH WKDW WKH GULYH OLQNV DUH DOLJQHG LQ WKH
bar groove.
Attach the bar to the chain saw and loop the chain
DURXQGWKHGULYHVSURFNHW
5HSODFHWKHVSURFNHWFRYHU
Adjust the chain tension. Refer to the “Adjusting the
chain tension” section.
WARNING
Improper chain sharpening increases the potential of
NLFNEDFN
WARNING
Failure to replace or repair a damaged chain can cause
serious injury.
WARNING
The saw chain is very sharp. Always wear protective
gloves when performing maintenance to the chain.
INSPECTING AND CLEANING THE CHAIN BRAKE
See page 25.
Ŷ $OZD\V NHHS WKH FKDLQ EUDNH PHFKDQLVP FOHDQ E\
OLJKWO\EUXVKLQJWKHOLQNDJHIUHHIURPGLUW
Ŷ $OZD\VWHVWWKHFKDLQEUDNHSHUIRUPDQFHDIWHUFOHDQLQJ
5HIHU WR ³2SHUDWLRQ &KHFNLQJ DQG 2SHUDWLQJ &KDLQ
%UDNH´HDUOLHULQWKLVPDQXDOIRUDGGLWLRQDOLQIRUPDWLRQ
MAINTENANCE SCHEDULE
Daily check
3RZHUFDEOHIRUGDPDJH Before each use
Bar lubrication Before each use
Chain tension Before each use and
IUHTXHQWO\
Chain sharpness Before each use, visual
FKHFN
For damaged parts Before each use
For loose fasteners Before each use
&KDLQEUDNHIXQFWLRQ Before each use
Inspect and clean
Bar Before each use
Complete saw After each use
&KDLQEUDNH Every 5 hours*
* Hours of operation
SYMBOLS ON THE PRODUCT
Safety alert
7RUHGXFHWKHULVNRILQMXU\XVHU
must read and understand operator’s
manual before using this product.
Wear eye, ear and head protection.
:HDUQRQVOLSVDIHW\IRRWZHDUZKHQ
using the product.
:HDUQRQVOLSKHDY\GXW\JORYHV