Ryobi RCS3535A - Page 48


English(original instructions)
EN
FR DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
42/5",%3(//4).'
02/",%- 0/33)",%#!53% 3/,54)/.
%NGINEWILLNOTSTART #LEANORREPLACESPARKPLUG2ESETSPARK
PLUGGAP2EFERTO 3PARK0LUG2EPLACEMENT
earlier in this manual.
[Make sure ignition switch Engine is flooded. 7ITHTHEIGNITIONSWITCH /&&, remove spark
is in the25.)position].  plug. Move choke lever to RUNposition
(pushed in completely) and pull starter cord

engine. Clean and reinstall spark plug. Set
ignition switch to RUNLposition. Push and
fully release primer bulb 7 times. Pull starter
three times with choke lever at RUNIf engine
does not start, move choke lever to &5,,
CHOKEand repeat normal starting procedure.
If engine still fails to start, repeat procedure
with a new spark plug.
Engine starts but will not Carburettor requires±,² Contact an authorised service centre for
accelerate properly. (Low jet)adjustment. carburettor adjustment.

Engine starts, then dies. Carburettor requires ±,² 
 adjustment. carburettor adjustment.
Engine starts but will not run #ARBURETTORREQUIRES±(² Contact an authorised service centre for
properly at high speed. (IGHJETADJUSTMENT carburettor adjustment.

Engine does not reach full speed Use fresh fuel and the correct 2-cycle
 
Air filter dirty. Clean air filter. Refer to #LEANINGTHE!IR 
 &ILTER in the Maintenance section of this
manual.
 Spark arrester screen dirty. Clean spark arrestor screen. Refer to
)NSPECTING#LEANINGTHE3PARK!RRESTOR
3CREEN in the Maintenance section of
this manual.

Carburettor requires±(² Contact an authorized service centre for
(High jet) adjustment. carburettor adjustment.
Engine starts, runs, and Carburettor requires adjustment 4urn idle speed screw ±4² clockwise to
accelerates but will not idle. to idle speed. increase idle speed. Refer to !DJUSTINGTHE
#ARBURETTOR in the Maintenance section of
this manual.
  ±4² counter clockwise
to idle speed. to decrease speed. Refer to !DJUSTINGTHE
#ARBURETTOR in the Maintenance section of
his manual.
Air leak in the intake system. Contact an authorised service centre for a
rebuild kit.