îî
English(original instructions)
EN
FR DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
î02/",%-î 0/33)",%î#!53%î 3/,54)/.
îBar and chain running hotîî Chain lubricant tank empty. Lubricant tank should be filled every time fuel tank
and smoking.îî is filled.
îî
Chain tension is too tight. Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of this
manual.
Oiler is not functioning. Run at half throttle 30 to 45 seconds. Stop saw
and check for lubricant dripping from guide bar.
If lubricant is present, the chain may be dull or
bar may be damaged. If no lubricant is present
contact an authorised service centre.
îEngine starts and runs, butîî Chain brake is engaged.î Release chain brake. Refer to Operating the
chain is not rotating. Chain Brake in the Operation section of this
manual.
îî
Chain tension is too tight. Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of this
manual.
Guide bar and chain assembled Refer to Replacing the Guide Bar and Chain in
incorrectly. the Maintenance section of this manual.
Guide bar and/or chain are Inspect guide bar and chain for damage.
damaged.
Drive sprocket teeth damaged Contact an authorised service centre for drive
sprocket replacement.
To Next Page
Loading...
Need help?
General
