Ryobi RE601 User Manual

THANK YOU FOR BUYING A RYOBI ROUTER.
Your new router has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and
operator safety. Properly cared for, it will give you years of rugged, trouble-free performance.
CAUTION: Carefully read through this entire owner's manual before using your new router.
Pay close attention to the Rules for Safe Operation, Warnings, and Cautions. If you use your router properly and only for what
it is intended, you will enjoy years of safe, reliable service.
Please fill out and return the Warranty Service Registration Card so we can be of future service to you.
Thank you again for buying Ryobi tools.
OWNER'S OPERATING MANUAL
Electronic Plunge Router
Heavy Duty Model RE601
Variable Speed / Double Insulated
SPECIFICATIONS:
Depth Of Plunge Cut 0 - 2-3/8 in. (0 - 60.3 mm)
Maximum Cutter Diameter 2-3/8 in. (60.3 mm)
Collet 1/2 in. (13 mm)
Bit Adapter Included With Packaging 1/4 in. (6.4 mm)
Amperes / Horsepower 15 Amperes / 3 Hp
Rating 120 Volts, 60 Hz, AC Only
No Load Speed 10,000 - 22,000 RPM
Power Cord 10 ft. (3 m)
Net Weight 15.5 lbs. (7.05 kg.)
SAVE THIS MANUAL FOR FUTURE REFERENCE
1
2
3
9
3
1
in cm

Ryobi RE601 Specifications

General

Motor Type	Brushed
Base Type	Fixed
Depth Adjustment	Yes
Soft Start	No
Collet Size	1/4 inch

Summary

Product Specifications

Typical Applications

Rules for Safe Operation

Safety Symbol Meanings

Eye Protection Requirement

Features Overview

Know Your Router

Adjustments and Settings

Installing/Removing Cutters

Step-by-step guide for installing and removing router cutters, including safety.

Cutter Tightening Caution

Setting the Depth of Cut (Zero Point)

Step-by-step guide to set the zero depth of cut reference point.

Setting Depth of Cut with Depth Stop

Explains how to adjust the depth control knob and depth stop for desired cut depth.

Depth Stop System Explained

Setting Depth Stop Settings

Provides detailed steps for setting the adjustable depth stops on the turret.

Setting Depth of Cut with Control Knob

Explains fine-tuning depth settings using the depth control knob.

Variable Speed Control Selector

Details how to use the variable speed control selector for optimal RPM settings.

Speed Selection Chart

Provides a chart for selecting appropriate router speeds based on cutter diameter and material.

Operation Guide

Pre-Operation Checks and Safety

Covers practice, safety warnings, holding the tool, and basic setup before routing.

Feed Direction and Rate

Details correct feed direction and the importance of selecting the proper rate of feed.

Feeding Techniques

Explains correct, force, and too-slow feeding to achieve quality cuts and avoid damage.

Depth of Cut Considerations

Discusses depth of cut impact on feed rate, quality, and potential damage.

Direction of Feed and Thrust

Explains how to manage thrust by planning feed direction for controlled routing.

Edge Routing Techniques

Edging with Pilot Bits

Freehand Routing Techniques

Explains how to use the router freehand for signs, relief sculptures, and patterns.

Freehand Routing Safety

Warns against using large bits for freehand routing to avoid loss of control.

Freehand Routing Methods

Maintenance Procedures

Depth Control Knob Adjustments

Step-by-step guide for adjusting or replacing the depth control knob assembly.

Depth Control Knob Caution

Brush Replacement Procedure

Extension Cord Safety

Service and Support Information