3
repaired.
for looseness before each
use. A loose bolt or nut may cause serious engine
problems.
Beware
that hearing protection will reduce your ability to hear
warnings (alarms or shouts). Pay more attention to what
is going on around the work area.
Never refuel indoors
or in a poorly ventilated area. Keep away from all sources
of ignition, sparks and flames.
where ignition sources
are present, such as hot water and space heaters, clothes
dryers, and the like.
handle fuel with care. It is highly flammable.
Use only
an approved container.
Never
remove the cap of the fuel tank or add fuel while the
engine is running or when the engine is hot.
to release pressure and
to keep fuel from escaping around the cap.
Move 9m
away from refuelling site before starting engine.
do not attempt to start the engine
but move the machine away from the area of spillage
and avoid creating any source of ignition until fuel vapors
have dissipated.
safely away from spark and/or flame-producing
equipment.
specifically designed
for this purpose.
before transporting in a vehicle.
Use of any other parts may
create a hazard or cause product damage.
Refer to them frequently
and use them to instruct other users. If you loan someone
this tool, loan them these instructions also.
Never operate the product without the safety guards in
place and in good condition.
Keep the working area free from wires, nails, metallic
cable, glass, stones and debris.
Do not cut against hard objects, this could cause injury or
damage the trimmer.
damp or wet locations or expose to rain. Keep work area
well lit.
.
.
at night, at times of heavy fog, or at
any other times when your field of vision might be limited
and it would be difficult to gain a clear view of area.
Be familiar with all controls and the proper use of the
machine.
Beware of overhead power lines.
If the cutting mechanism strikes any foreign object or
the machine should start making any unusual noise
or vibration, shut off the power source and allow the
machine to stop. Disconnect the spark plug wire from the
spark plug and take the following steps:
1. Inspect for damage;
2. Check for and tighten any loose parts;
3. Have any damaged parts replaced or repaired with
parts having equivalent specications.
Stop the engine and disconnect the spark plug wire from
the spark plug before
1. Adjusting the working position of the cutting device;
2. Cleaning or clearing a blockage;
3. Checking, maintenance or working on the machine.
Do not inhale fuel fumes as they are toxic.
dry brush, twigs, cloth
rags, or other flammable materials.
if ice has formed in any
part of the equipment.
on this product. These products can cause
physical injuries to the operator and irreversible damage
to the machine.
(except
where specifically recommended by the manufacturer).
(recoil starter area)
and muffler side of the engine at least 1m away from
buildings, obstructions, and other flammable objects.
The muffler and other
engine parts become very hot, use caution.
when starting and operating the engine.
for looseness and
fuel leakage before each use. Do not use until properly
To Next Page
Loading...
