EasyManua.ls Logo

Ryobi RHT2660DAG - Filling the Tank; Starting and Stopping; To Start a Cold Engine; To Start a Warm Engine

Ryobi RHT2660DAG
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8



Petrol is extremely ammable and explosive. A re or
explosion from petrol will burn you and others. Always
shut off engine before fuelling. Never add fuel to a
machine with a running or hot engine. Move at least
10m from refuelling site before starting engine. Do not
smoke and stay away from open ames and sparks.
Failure to safely handle fuel could result in serious
personal injury.
Position the hedge trimmer on its side with the fuel cap
pointing upward.
Always refuel outdoors in a well ventilated area away
from sparks, flames and other ignition sources. Choose a
hard level surface for this task.
Clean surface around fuel cap to prevent contamination.
Loosen fuel cap slowly. Rest the cap on a clean surface.
Carefully pour fuel into the tank. Avoid spillage.
Clean and inspect the fuel cap gasket before replacing
the fuel cap.
Replace fuel cap and hand tighten. Wipe up any fuel
spillage.
Move at least 10m away from refuelling area before
starting the product.
 It is normal for smoke to be emitted from a new
engine during rst use.

Check for fuel leaks. A leaking fuel cap is a re hazard
and must be replaced immediately. If you nd any leaks,
correct the problem before using the product. Failure
to do so could result in a re that could cause serious
personal injury.

See Figures 2 - 4.
The starting method differs depending on whether the
engine is cold or warm.

When the engine starts with the choke in the COLD
START position, the blades will move. Keep body,
objects, and obstructions away from blades. Failure to
keep away from the blades can result in serious injury.

DO NOT squeeze the throttle trigger until the engine
starts and runs.
Place the hedge trimmer on level ground and ensure that
no objects or obstructions are in the immediate vicinity
Fig. 3
Fig. 4
Fig. 2
on/off
switch
tRiGGER
lock
stARt
RUn
thRottlE
tRiGGER
