Ryobi RLT26CDS - Intended Use; General Safety Rules

2
English (Original Instructions)
Set the choke lever to “Run” choke position.
Pull the starter grip until the engine attempts to start.
Wait for 10 seconds.
Stop the engine.
Set the ignition switch to the “I” (ON) position.
Ignition switch: 0 = STOP, I = RUN
When tting the line spool to the cutting means, this symbol should be visible to the operator.
Conforms to all regulatory standards in the country in the EU where the product is purchased.
EurAsian Conformity Mark
Ukrainian mark of conformity
The guaranteed sound power level is 113 dB.
The following signal words and meanings are intended to explain the levels of risk associated with this product.
Symbol Signal Meaning
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.