EasyManua.ls Logo

Ryobi RLT26CDSN - User Manual

Ryobi RLT26CDSN
12 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TWO STROKE PETROL LINE TRIMMER
ORIGINAL INSTRUCTIONS
RLT26CDSN
Important! It is essential you read the instructions in this manual before starting and
operating this machine.
Subject to technical modications.

Table of Contents

Questions and Answers

  • A
    Ann TorresAug 8, 2025
    Why is my Ryobi RLT26CDSN Trimmer engine not reaching full speed and emitting excessive smoke?
    • J
      Joseph BestAug 8, 2025
      If your Ryobi Trimmer's engine doesn't reach full speed and emits excessive smoke, it could be due to a few factors. First, ensure you're using fresh fuel and the correct 2-stroke oil mix. Also, a dirty air filter can cause this issue; clean it according to the instructions in the Maintenance section. Finally, a dirty spark arrestor screen might be the culprit, in which case you should contact an authorized service dealer.
  • M
    Michelle StewartAug 15, 2025
    What to do if the cutting line will not advance when using bump feed action on my Ryobi RLT26CDSN Trimmer?
    • N
      Nicholas HuynhAug 15, 2025
      There are several reasons why the cutting line on your Ryobi Trimmer might not advance when using the bump feed action. The line might be welded to itself, in which case you should lubricate it with silicone spray. It's also possible that there isn't enough line on the spool, so install more line. If the line is worn too short, pull it while alternately pressing down on and releasing the retaining cap. Another reason might be that the line is tangled on the spool; remove the line and rewind it. Also, make sure the engine speed isn't too slow; advance the line at full throttle. Finally, check if the line spool is installed backward, ensure the writing on the line spool is facing the correct way; THIS SIDE OUT FOR CURVED SHAFT.
  • R
    Rebecca BlackAug 21, 2025
    Why does grass wrap around the trimmer head assembly and the attachment shaft of my Ryobi RLT26CDSN Trimmer?
    • K
      Kimberly LewisAug 21, 2025
      If grass wraps around the trimmer head assembly and the attachment shaft of your Ryobi Trimmer, it's likely because you're cutting tall grass at ground level; try cutting tall grass from the top down. Also, operating the product at part throttle can cause this; operate the product at full throttle.
  • B
    Brandon ThomasAug 27, 2025
    Why is oil dripping from the muffler of my Ryobi RLT26CDSN?
    • M
      Mary AndersonAug 27, 2025
      If oil drips from the muffler of your Ryobi Trimmer, it could be due to a few reasons. Operating the product at part throttle can cause this, so try operating it at full throttle. Also, check your oil/fuel mixture and ensure you're using fresh fuel and the correct 2-stroke oil mix. A dirty air filter might also be the cause; in this case, clean the air filter according to the instructions in the Maintenance section.
  • M
    Marissa BakerNov 2, 2025
    Why won't my Ryobi RLT26CDSN start?
    • M
      Melissa RodriguezNov 2, 2025
      If the engine of your Ryobi Trimmer doesn't start, it might be due to several reasons. First, ensure the switch is in the I (ON) position. If that's not the issue, check for a spark by removing the spark plug, reattaching the cap, laying it on the metal cylinder, and pulling the starter cord. If there's no spark, try a new spark plug. Another possibility is no fuel; push the primer bulb until it's full. If it doesn't fill, the fuel delivery system may be blocked. Lastly, if the engine is flooded, remove the spark plug, turn the product so that the spark plug hole is aimed at the ground, ensure the choke lever is set to Run position and pull the starter cord 10 to 14 times to clear excess fuel. Clean and reinstall the spark plug. With the throttle trigger fully depressed, pull the starter c...

Summary

General Safety Warnings

Physical Condition of the Operator

Operator's physical and mental state when using the product.

Clothing Requirements

Appropriate attire for safe operation, avoiding loose clothing.

Protective Accessories Requirements

Mandatory use of eye and hearing protection.

Proper Stance and Balance

Exhaust Gases

Fueling Safety

Work Area Safety

Clearing objects and bystanders from the operating zone.

Assembly and Installation

Attaching Power Head to Trimmer Attachment

Installing Reel Easy Line Trimmer Head

Installing Line in Reel Easy Line Trimmer Head

Operation and Fueling

Fuel and Refueling Safety

Safe handling of flammable fuel and refueling procedures.

Mixing the Fuel

Correct ratio and method for mixing petrol and 2-stroke oil.

Filling the Tank

Steps for safely filling the fuel tank.

Starting and Operating the Trimmer

Starting the Product

Procedures for starting a cold or warm engine.

Stopping the Product

Operating the Trimmer

Proper technique for using the trimmer.

Advancing the Cutting Line

Maintenance

Cleaning the Air Filter

Replacing the Spark Plug

Short Term Product Storage

Troubleshooting

Engine Will Not Start

Engine Does Not Reach Full Speed

Cutting Line Not Advancing

Ryobi RLT26CDSN Specifications

General IconGeneral
BrandRyobi
ModelRLT26CDSN
CategoryTrimmer
LanguageEnglish

Related product manuals