Need help?Do you have a question about the Ryobi RPL780 and is the answer not in the manual?
General| Voltage | 120 V |
|---|---|
| No Load Speed | 16, 500 RPM |
| Power Source | Corded Electric |
| Planning Width | 3-1/4 inches |
| Maximum Cut Depth | 1/8 in |
Keep work area clean, well lit, and free of flammable materials.
Ensure proper grounding, avoid wet conditions, and protect the power cord.
Stay alert, use PPE, and avoid unintentional starting.
Use the correct tool, maintain it, and store it properly.
Wait for cutter to stop, hold by insulated surfaces, secure workpiece.
Avoid operating with dull blades, sharp edges, or removing debris while running.
Slide the collar of the dust bag onto the exhaust port.
Change debris direction by moving the exhaust dial.
Turn knob clockwise to set depth up to 3.0 mm.
Use lock-off button and switch trigger to start; release trigger to stop.
Clamp workpiece, use two hands, plane slowly, and empty dust bag often.
Kickstand retracts during use and deploys when set down.
Clamp workpiece, adjust depth, use two hands, and push steadily.
Use the groove in the front shoe to chamfer corners.
Use adjustable edge guide for precision edge planing and rabbet cutting.
Attach bracket and edge guide to the side for planing edges.
Hold edge guide firmly against workpiece edge while planing.
Attach bracket and edge guide to the left side for rabbet cuts.
Rest edge guide against workpiece edge; depth determined by passes.
Cord replacement must be done by authorized service center.
Clean chips from exhaust port and empty dust bag regularly.
Blades are reversible; replace in pairs using recommended parts.
Remove belt cover, force old belt off pulleys, install new belt.
To Next Page
