Ryobi rsds680 - Environmental Protection

2 | English
ŶElectric tools used on fiberglass material, wallboard,
VSDFNOLQJFRPSRXQGVRUSODVWHUDUHVXEMHFWWR
accelerated wear and possible premature failure
because the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutators,
etc. Consequently, we do not recommend using the
product for extended work on these types of materials.
+RZHYHULI\RXGRZRUNZLWKDQ\RIWKHVHPDWHULDOV
it is extremely important to clean the product using
compressed air.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
ŶIf the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorized service
center to avoid risk. Contact authorized service center.
ŶFor greater safety and reliability, all repairs should be
performed by an authorised Ryobi service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
VXI¿FLHQWDPRXQWRIKLJKJUDGHOXEULFDQWIRUWKHOLIHVSDQRI
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SYMBOLS
Safety alert
Class II tool, double insulation
+DPPHUPRGH
&KLVHODGMXVWPHQWPRGH
+DPPHUGULOOPRGH
Drill mode
CE conformity
EurAsian Conformity Mark.
Please read the instructions carefully before
starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.