INSTALLATION MANUAL T7 DIVING SYSTEM™
4
srsmith.com
The specifications found on page 5 of this manual represent the minimum water envelope required by S.R.Smith and
by the ANSI/APSP/ICC-5 2011 Standard for Residential Inground Swimming Pools. Each of these dimensions must
be met or exceeded. Installation of a diving board of any type on a pool that does not meet or exceed each of the
minimum specifications as provided on page 5, including but not limited to the slope requirement, is in direct violation
of this manufacturer’s instructions and the 2011 Standard, and can result in serious injury or death.
The installation of the T7 diving system is not complete until you, the installer have measured the pool to ensure it
meets the S.R.Smith residential inground minimum pool specifications and the ANSI/APSP/ICC-5 2011 Standard for
Residential Inground Swimming Pools
The installation of the T7 diving system is not complete until you the installer has delivered to your customer and
reviewed with your customer the “Owners Manual” as well as the “Plan Your Dive Steer-Up” brochure.
The T7 diving system (diving board, springs, and base) is a complete system and must be installed as a complete system.
It is strictly prohibited to install any T7 component on any other stand, spring, or base.
S.R.Smith highly recommends that you, the installer, obtain and consult the ANSI/APSP/ICC-5 2011 Standard for
Residential Inground Swimming Pools before proceeding with the installation.
CHECK YOUR LOCAL ELECTRICAL CODE FOR BONDING REQUIREMENTS. USE ANTI-SEIZE ON ALL
HARDWARE.
THE T7 DIVING SYSTEM IS A JUMP BOARD.
ONLY ONE PERSON AT A TIME ON THE DIVING BOARD,
WITH A MAXIMUM WEIGHT LIMIT OF 300 LBS.
IMPORTANT NOTICES
TO THE INSTALLER
To Next Page
Loading...