S2 NetBox Enterprise - Logging In to NetBox Enterprise; Connecting Nodes and System Resources

3. A Password prompt appears. Enter admin.
4. An IP settings screen appears. Use the UP/DOWN arrow keys to select a setting and press
Enter to edit the setting.
5. The Current value for the setting displays at the bottom of the screen.
6. Beneath the Current value next to the New value prompt, enter the new value for this setting
and press Enter.
7. Use the arrow keys to move the highlight down to Save changes and press Enter. The IP
setting changes that you have made are now saved to the NetBox Enterprise.
8. Repeat steps 5 through 8 to make any further changes to the NetBox Enterprise IP settings.
9. Use the arrow keys to highlight Exit and press Enter.
Logging in to your NetBox Enterprise
Login
NOTE: The default IP address of a NetBox Enterprise is 192.168.0.250. If you changed this
in previous steps then enter the new address here.
1. Open your browser and enter the NetBox Enterprise IP address into the address line. Press
the Enter key
2. At the Login page enter the User name “admin.”
3. Enter the Password “admin.”
4. Click Go. The security application will now display.
Connecting Nodes and Configuring System Resources
Configure and Enable the Nodes.
1. In the application select Setup : Site Settings : Network Nodes.
2. Select from the Name drop-down the node you wish to enable.
NOTE: If there are many nodes it is recommended that you power up one node at a time.
This will help avoid confusion.
3. Click the Rename link under the drop-down and enter a name that will help you to identify it,
e.g. "Office node," “Parking Garage node.”
NOTE: Do not change the Unique Identifier field.
4. Click to check the Enabled box to the right of the Name drop-down. This allows the
communication of security data between the Network Controller and the Node.
5. Click Save.
6. Repeat steps 2 through 5 with each node in the system.
7. Select Setup : Site Settings : Network Controller.
8. Check that the nodes are now connected to the NetBox Enterprise controller. Each node
should appear in green with the word Connected.
4