SAB Heli Division Goblin 570 User Manual

Detailed specifications including rotor diameter, blade length, and dimensions.

Crucial safety warnings and general precautions for operating the helicopter.

Rules for safe operation, flying areas, and handling precautions.

Guidance on following assembly order and using thread lockers.

List of essential components and tools needed for assembly.

Breakdown of parts included in each box and tray.

Information on carbon part manufacturing and edge preparation.

Instructions for assembling the main frame and battery support.

Steps for assembling the carbon fiber landing gear.

Introduction to the transmission assembly process.

Instructions for assembling servo and bearing supports.

Steps for installing main pulleys and tail pulley assemblies.

Details on installing motor support and related pulleys.

General guide to assembling the main rotor components.

Steps for assembling uniball radius arms, radius arms, and center hub.

Instructions for assembling main blade grips and linkage rods.

Instructions for installing the tail servo and related components.

Steps for mounting swashplate servos and final assembly.

Detailed steps for assembling the swashplate.

Guidance on adjusting linkages for head setup and linkage rods.

Information on choosing the right ratio and motor configurations.

Procedures for correctly tensioning the motor drive belt.

Recommendation to de-burr carbon frame edges for wiring safety.

Steps for installing the electronic speed control (ESC) and routing wires.

Guide to installing the flybarless system and receiver.

Steps for assembling the FBL unit and mounting it.

Instructions for assembling the tail rotor hub and pitch slider.

Steps for installing the tail case, bell crank, and system.

Guidance on assembling the tail boom and its components.

Steps for installing the boom and adjusting tail belt tension.

Instructions for installing 6S and 12S batteries and checking CG.

Steps for installing the canopy, grommets, and edge protection.

Guidance on installing the serial number tag and product registration.

Essential checks before flight, including transmitter setup and belt tension.

Recommendations for checking wear, lubrication, and post-flight inspections.

Diagram and parts list for the carbon frame assembly.

Diagram and parts list for the transmission assembly.

Diagram and parts list for the head system components.

Diagram and parts list for the tail system components.

List of spare parts for frame, motor, transmission, pulleys, and shafts.

List of spare landing gear, canopy, servo blocks, and carbon parts.

List of spare springs, bearings, belts, and optional upgrades/accessories.