EasyManua.ls Logo

Saba LV10C44MINI-PLIX - Prior Using for the First Time

Saba LV10C44MINI-PLIX
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Prior using for the rst time
Before using your dishwasher for the rst time:
A. Set the water softener
B. Add 1.5Kg dishwasher salt and then full ll the salt container
with water
C. Fill the rinse aid dispenser
D. Fill in detergent
A. Water Softener
The water softener must be set manually, using the water
hardness dial.
The water softener is designed to remove minerals and salts
from the water, which would have a detrimental or adverse
eect on the operation of the appliance.
The higher the content of these minerals and salts, the
harder your water is.
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the
amount of salt consumed based on the hardness of the water
used. This is intended to optimise and customise the level of salt
consumption.
Please follow the steps below for adjustment in salt consump-
tion.
1. Open the door .Switch on the appliance;
2. Press the Program button for more than 5 seconds to start
the water softener set model within 60seconds after the
appliance was switched on( The Salt and Rinse aid warning
lights will be on periodically when it get in the set model);
3. Press the Program button to select the proper set according
to your local environment, the sets will change in the follow-
ing sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the set up model.
WATER HARDNESS
Selector
Position
Salt consumption
(gram/cycle)
°dH °fH °Clarke mmol/l
0-5 0-9 0-6 0-0.94 H1 0
6-11 10-20 7-14 1.0-2.0 H2 9
12-17 21-30 15-21 2.1-3.0 H3 12
18-22 31-40 22-28 3.1-4.0 H4 20
23-34 41-60 29-42 4.1-6.0 H5 30
35-55 61-98 43-69 6.1-9.8 H6 60
Note: 1
1 “dH=1,25°Clark=1.78 °fH=0.178mmol/l
°dH: German degree
°fH: French degree
°Clark: British degree
Note: 2
The manufactory setting: H3 (EN 50242)
Contact your local water board for information on the hardness of
your water supply.
7776
GB
GB

Related product manuals