Syphon Connection
The waste connection must be at a height less than 1000 mm
(maximum) from the bottom of the dish. The water drain hose
should be xed.
Start of Dishwasher
The following things should be checked before starting the dish-
washer.
1. The dishwasher is level and xed properly
2. The inlet valve is open
3. Fill hose connections are fully tightened and not leaking
4. The wires are tightly connected
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from
the dishwasher
Attention: After installation, please make sure to keep
this manual. The content of this manual is very helpful to the
users.
9. Troubleshooting Tips
Before Calling for Service
Review the charts on the following pages may save you from call-
ing for service.
Problem Possible Causes What to Do
Technical problems
Dishwasher doesn’t start Fuse blown, or the circuit
breaker acted
Replace fuse or reset cir-
cuit breaker. Remove any
other appliances sharing
the same circuit with the
dishwasher
Power supply is not
turned on
Make sure the dishwasher
is turned on and the door
is closed securely.
Make sure the power cord
is properly plugged into
the wall socket.
Water pressure is low Check that the water
supply is connected
properly and the water is
turned on.
Door of dishwasher not
properly closed
Make sure to close the
door properly and latch it.
water not pumped from
dishwasher
Kink in drain hose Check drain hose.
Filter clogged Check the coarse lter
(see section titled « Clean-
ing The Filter»)
Kitchen sink clogged Check the kitchen sink to
make sure it is draining
well.
If the problem is the
kitchen sink not draining
,you may need a plumber
rather than a serviceman
for dishwashers
107106
To Next Page
Loading...
