Saba LV10C44MINI-PLIX - Page 56

Problem Possible Causes What to Do
General problems
Suds in the tub Improper detergent Use only the special
dishwasher detergent to
avoid suds.
If this occurs, open the
dishwasher and let suds
evaporate.
Add 1 gallon of cold water
to the tub. Close and latch
the dishwasher, then se-
lect any cycle. Dishwasher
will drain out the water
at the rst step. Open the
door after draining is stop
and check if the suds is
disappeared.
Repeat if necessary.
Spilled rinse-aid Always wipe up rinse-aid
spills immediately.
Stained tub interior Detergent with colourant
was used
Make sure that the deter-
gent is the one without
colourant.
White lm on inside
surface
Hard water minerals To clean the interior, use
a damp sponge with
dishwasher detergent
and wear rubber gloves.
Never use any other
cleaner than dishwasher
detergent for the risk of
foaming or suds.
There are rust stains on
cutlery
The aected items are
not corrosion resistant.
A programme was not
run after dishwasher salt
was added.
Traces of salt have gotten
into the wash cycle.
Always run the quick
wash programme without
any crockery in the
dishwasher and without
selecting the Turbo
function (if present), after
adding dishwasher salt,
The lid of the softer is
loose
Check the lid .Ensure the
x is ne.
Problem Possible Causes What to Do
Noise
Knocking noise in the
wash cabinet
A spray arm is knocking
against an item in a
basket
Interrupt the programme,
and rearrange the items
which are obstructing the
spray arm.
Rattling noise in the
wash cabinet
Items of crockery are
loose in the wash
cabinet
Interrupt the programme,
and rearrange the items
of crockery.
Knocking noise in the
water pipes
This may be caused by
on-site installation or
the cross-section of the
piping.
This has no inuence on
the dishwasher function,
if in doubt, contact a suit-
ably qualied plumber.
Unsatisfactory wash-
ing result
The dishes are not clean The dishes were not
loaded correctly.
See notes in “Loading the
Dishwasher Baskets".
The programme was not
powerful enough.
Select a more intensive
programme. See" Wash
Cycle Table".
Not enough detergent
was dispensed.
Use more detergent, or
change your detergent.
Items are blocking the
path of spray arms.
Rearrange the items so
that the spray can rotate
freely.
The lter combination in
the base of wash cabinet
is not clean or is not
correctly tted. This may
cause the spray arm jets
to get blocked.
Clean and/or t the lter
combination correctly.
Clean the spray arm jets.
See "Cleaning the Spray
Arms".
Cloudiness on glassware Combination of soft
water and too much
detergent.
Use less detergent if you
have soft water and select
a shortest cycle to wash
the glassware and to get
them clean.
Black or gray marks on
dishes
Aluminum utensils have
rubbed against dishes.
Use a mild abrasive
cleaner to eliminate those
marks.
Detergent left in
dispenser cups
Dishes block detergent
cups.
Re-loading the dishes
properly.
109108
GB
GB