SAC T120 - Default Chapter; Table of Contents

T120C
I
1 INTRODUCTION 1....................................................
1.1 MACHINE DESCRIPTION 1.................................................
1.2 CONFORMITY 1...........................................................
1.3 MACHINE IDENTIFICATION 2...............................................
1.3.1 Machine identification 2...................................................
1.3.2 Correspondence 2.......................................................
1.3.3 Service recommendations 3...............................................
1.3.4 Final test report 4........................................................
2 WORKING SAFETY 7.................................................
2.1 GENERAL SAFETY RULES 7................................................
2.1.1 Operator training 7.......................................................
2.1.2 Safety plates 8..........................................................
2.1.3 Symbols 10..............................................................
2.2 MACHINE CORRECT AND IMPROPER USE 11................................
2.2.1 Number and position of the working places 11................................
2.3 INDIVIDUAL RISK FACTORS 12..............................................
2.4 ENVIRONMENTAL RISK FACTORS 12........................................
2.5 RISK FACTORS CONNECTED WITH THE MACHINE USE 12....................
2.6 PROTECTI ON AND SAFETY DEVICES 13.....................................
2.7 RESIDUAL RISKS 15........................................................
2.8 ENVIRONMENTAL SAFETY 15...............................................
2.8.1 Noise emission 15........................................................
2.8.2 Dust emission levels 16....................................................
2.8.3 Machine removal and demolition 16.........................................
2.8.4 Emergencies 16..........................................................
3 MACHINE INSTALLATION 17...........................................
3.1 HANDLING - TRANSPORT - STORAGE 17.....................................
3.1.1 Lifting method 17.........................................................
3.1.2 Storage 18...............................................................
3.2 POSITIONING 19...........................................................
3.2.1 Positioning and foundations 19.............................................
3.2.2 Min. spaces for a safe use 19...............................................
3.3 MACHINE PREPARATION FOR THE START-UP 19.............................
3.3.1 Check of the machine possible damages 19..................................
3.3.2 Machine installation 20....................................................