SAC T120 - Machine Identification; Correspondence

T120C
2
1.3 MACHINE IDENTIFICATION
1.3.1 Machine iden t ificatio n
The machine is identified by the writings shown on the plate (Fig. 1) placed on the base -
ment as indicated in Fig. 2.
’’
Fig. 1: Machine identification plate.
’’
3~HzV
Curr ent r ating/Intensite
Tensione/Spannung
Voltage/ Tension
gir i/ mi n
UpM
rpm
t/mn
Veloci ta’
Dr ehzahl
Vitesse
#f8 mas si mo utens il e
Max. Werkzeug #f8
Max . tool #f8
Outil maxi #f8
mm
mmCutters/F raises
Nr ./Ser i ennumm er /Ser ial No.
No.d’immatriculation
Fig. 2: Position of the identification plate
1.3.2 Correspondence
When communicating with the Dealer or the Technical Service Center or the Manufac-
turer, for any reason concerning the machine, always refer to the following data: