SAC T120 - 7 Technical and Environmental Data; Technical Data

T120C
67
7 TECHNICAL AND ENVIRONMENTAL DATA
7.1 TECHNICAL DATA
MU T120
STANDARD FEATURES
Spindle start direct remote starter with push button f
Motor magneto-thermal protection f
Automatic motor brake f
Speed reversal f
Grooving on table f
Spindle rotation speed No. 5
Rings on table No. 5
Front handwheel for shaft vertical positioning f
Indication of the vertical incremental position of the shaft f
Protection for the guide machining with suction hood f
Manufacturing guide (protection) with 2 adjustments:
entry front drive only
exit front drive only
f
Shaft locking knob on front control panel f
Suction hoods No. 2
Electro-welded sheet basement f
Casing for tenons with suction hood, inlet ∅ 140 mm and with emergency
push button
-
TECHNICAL DATA
Machining table dimensions:
Length
Width
mm 1300
800
Machining table height mm 903
Fixed spindle shaft diameter and
Shaft length (EN 848-1)
inch
mm
1” 1/4”
140
7