SAC T120 - Page 5

T120C
III
4.9 SHAFT MACHINING PROCEDURES 46.......................................
4.9.1 Milling with the curved guide 46.............................................
4.9.2 Milling with inlet ring 50....................................................
4.10 Tenoning procedure with sliding table 53........................................
4.10.1 Tenoning sliding table 53...................................................
4.10.2 Adjustment of the protecting device for tenoning operations 55..................
4.10.3 Tenoning of straight pieces 56..............................................
4.10.4 Tenoning of sloped pieces 56...............................................
5 MAINTENANCE 59.....................................................
5.1 M AINTENANCE AND SAFETY 59.............................................
5.1.1 Safety measures 60.......................................................
5.1.2 Tool maintenance 60......................................................
5.2 ELECTRIC SYSTEM MAINTENANCE 60.......................................
5.3 SELF-BRAKING MOTOR 61..................................................
5.3.1 Entrefer adjustment 61....................................................
5.3.2 Replacement of the movable anchor - brake disk (12) 62.......................
5.3.3 Replacing the electro-magnet (11) 63........................................
6 WHAT YOU MUST DO IF... 65...........................................
6.1 FOREWORD 65.............................................................
6.1.1 The spindle overload cutout does not reset 65................................
6.1.2 The spindle motor rotates always braked 65..................................
6.1.3 The spindle motor overload cutout has intervened at the switching-on 66.........
6.1.4 The overload cutout of the spindle motor has intervened 66.....................
6.1.5 Piece surface being machined not smooth 66.................................
7 TECHNICAL AND ENVIRONMENTAL DATA 67...........................
7.1 TECHNICAL DATA 67.......................................................
7.2 OVERALL DIMENSIONS 71..................................................