Sachs SA 340 - Page 23

Fan, starter hub and recoil starter
Place faf\ (1, Fig. 2) with gasket in position and secure it with 4 nuts M 6 and spring
washers.
Torque 0.5 . .. 0.6 kpm (3.6 .. .4.3 ft. lb.).
Insert
two cyli ndrical pins 4 dia. x 15 and fit spacer.
Place starter hub (2, Fig. 2) in position and fit washer and tab washer. Hold it with
retaining lever (3, Fig. 2) and secure starter hub with he xa gon nut (with collar )
M 14 X 1.5.
Torque 9.0 ... 9.5 kpm (65.1 ... 68.7 ft. lb.).
Secure recoil starter with 6 nuts M 6 and spring washers.
Electric starter, carburettor and intake silencer
Screw on electric starter with two nuts M 8 and spring w ashers.
Conn " ect impulse pipe (4, Fig. 1) to connection on crankcase.
Plac e on both insulating bush es, insulating flang e, carburettor and both fibre washers
(hard cloth side towards carburettor) and screw carburettor firmly into place on the
flange (1, Fig. 1) wit h 2 self-locking nuts M 6 (for carburettor HR 18 A) and M 8 (for
co
rburettor H D 13 A) respectively.
Fit intake silencer (3, Fig. 1) and secure it.
Exhaust muffler and baffle plate
Screw on exhaust muffler or manifold and bracket respectively.
If there is a baffle plate on SACHS SA 340 and SA 370, screw tight exhaust muffler or
manifold respectively on the right-hand stud screw with a nut M 8 x 22.5. Screw baffle
plate with 1 cylinder head screw M 8 x 12.5 to nut and 1 cylind er head screw M 6 x 10
with
earth lead (in case of rig ht -hand carburettor) and cover to fan shroud.
27